Pharmacy Bench Setup: Rx Tape and Cold Seal Refill Kit Steps

Quick answer

Set up the bench in three zones: tape and labels on the left, the Unit Dose Cold Seal Refill Kit in the center, and a punch-and-check area on the right. Keep Apothecary Rx Tape within reach for vials and card receipts, and reserve a separate tamper-evident tape for prescription bag sealing.

Bench setup steps

1. Clear and divide the bench into three zones: Set a tape-and-label zone on the left, the Unit Dose Cold Seal Refill Kit in the center, and a punch-and-check zone on the right. Keep the center clear of clutter so the clear blister stays visible during filling. Checkpoint: no loose vials or ointment tubes should sit in the center fill zone.
2. Place Apothecary Rx Tape at the vial-labeling station: Put the tape within arm's reach of where you affix labels to prescription vials and ovals. Do not place it beside ointment tubes, because the tape is not recommended for ointment tubes. Checkpoint: label the tape dispenser 'vials and ovals only' if the bench is shared.
3. Set up the refill kit card and blister flow: Lay out the disposable card and blister so the clear side faces you, then fill and verify before punching through the foil backing. Keep the punch station on the right so dispensed cards do not return to the fill area. Checkpoint: confirm the foil backing is intact before filling, since a punched card cannot be refilled.
4. Separate bag-sealing tape from label tape: Keep a dedicated tamper-evident tape at the bagging end of the bench for prescription bag sealing. Use Apothecary Rx Tape only for labels and receipts, not as a bag seal. Checkpoint: two distinct tape rolls should be visible, one at labeling and one at bagging.
5. Run a five-minute end-to-end test: Label one vial, fill one 31-day card, punch one dose, and seal one bag. Time the run and note where you reached across zones or hesitated between tapes. Checkpoint: if any step requires crossing two zones, move that supply closer before the next shift.

Product facts

• Apothecary Products® Unit Dose Cold Seal Refill Kit: Organizes up to 31 days of medication on a disposable card and blister, with pills visible through the clear blister and punched through the foil backing when dispensed. A visible, punch-through card lets you confirm at a glance whether a dose has been taken, which supports a fill-check-punch routine at the bench.

  

• Apothecary Rx Tape: Apothecary Rx Tape is ideal for affixing labels to prescription vials and ovals, with a long-lasting adhesive, but is not recommended for ointment tubes. Keeping this tape at the vial-labeling station and away from ointment tubes prevents labels from lifting where the tape was not designed to hold.